Quartz Epoxy Flooring Questions

Light foot traffic is typically possible within 24 hours of the final topcoat. Full cure for heavy loads or vehicle traffic takes around 72 hours. The written estimate states the exact cure schedule for your specific topcoat product and the conditions on the day of installation.

Yes, but cracks must be repaired and the slab profiled before the primer goes down. The quartz layer adds thickness that bridges minor surface irregularities, but it cannot compensate for structural cracks or a slab that has not been properly prepped. The on-site assessment identifies what repair work is needed.

Vapor pressure from below pushes through the epoxy bond, causing bubbling and delamination, sometimes within weeks of installation. Older Phoenix commercial slabs are particularly prone to this. The installer tests for moisture intrusion during the assessment and specifies a barrier if the slab requires one.

Yes. Aggregate color and topcoat sheen are selected together because the quartz shows through the clear coat. The written estimate lists the chosen aggregate color and topcoat type so both parties agree on the finish before installation begins.

It is commonly specified for covered pool surrounds and patios. UV-stable aggregate colors resist fading, and the textured surface handles bare feet and standing water. Fully exposed outdoor areas should be discussed at the assessment, since direct UV exposure affects topcoat selection.

Routine cleaning with a neutral-pH cleaner and a mop is sufficient. Avoid abrasive scrubbers that can dull the topcoat over time. The installer will confirm the recommended cleaning products for your specific topcoat at the final inspection.